How To Light A Pilot Light On A Goodman Furnace
How To Light A Pilot Light On A Goodman Furnace. Unless you have a furnace dating 35years or more, no. This is usually a white or red plastic knob that is on top of the main gas valve.
Hold down the reset button and relight the pilot at the same time. Subsequently, one may also ask, where is the pilot light on my furnace? After a few seconds, the pilot will light up, igniting the furnace’s burners.
Goodman Furnace Won’t Turn On/Won’t Ignite.
This is usually red and should have settings for “off,” “on,” and “pilot.”. When you realize that you relight the pilot light, release the button. Then, hold down the “reset” button, bringing the flame of a long lighter close to the pilot light opening.
There Is No Door To Open It Unless I Take The Front Panel Off With A Screwdriver Matthew :
Once you are sure the pilot light is on, release your pressure on the reset button. Furthermore, why is my goodman furnace not lighting? If the goodman furnace still doesn't light at the burner level, even after ensuring the gas supply is on and the proper ignition sequence was followed, turn off the furnace and ensure the furnace is cool.
After That, Press The Reset Button For A While And Use A Long Lighter Flame Near The Opening Of The Pilot Light.
Once you are sure that the pilot light is on, release your pressure on the reset button. How to light a pilot light on a rheem furnace. After waiting five or 10 minutes for the gas to clear out, turn the gas valve to “pilot.”.
A Goodman Furnace That’s Not Turning On (Won’t Ignite) Has Power Or Gas Supply Issues, Restricted Airflow, A Bad Thermostat, Wrong Ignition Sequence, A Dirty Pilot Light Hole, Or A Dirty Or Defective Flame Sensor.
Relight the pilot light with the ignition button, if your furnace has one. After locating the reset button, it’s time to turn the knob of the furnace to pilot. Locate the gas control knob inside the burner compartment.
The Unit Is Located In The House In A Small Enclosure.
This should light the furnace pilot light. Using a flashlight if necessary, note the small pilot gas tube leading from the main gas valve and extending into the burner area; That's the one you have to take off.